The Problem of Longitudinal Shear Assembly
Longitudinal shearing machine, as a kind of machine and equipment, its application is still very extensive, so it will certainly encounter a variety of problems in the application. Here are a few common problems for you to briefly introduce:
1. In the production line of cross-cutting line, can it be equipped with vertical shears?
Answer: The production line of cross-cutting line is mainly composed of feeding trolley, uncoiler, leveler, feeding mechanism, shearing machine, conveying device and stacking device. Its production line can be equipped with longitudinal shears, so that the sheet can be sliced, cut into the required width, etc., for subsequent processing.
2. What is the feed rate of the longitudinal shear blade? Is it related to the tightening machine when the sheet runs to one side during winding?
Answer: Each feed of longitudinal shears should not exceed 0.02mm, and if it is of high accuracy, it should be 0.005mm. When winding, the sheet metal deviation is generally not related to the tightening machine, which may be caused by problems in installation.
3. How to avoid wear and tear of longitudinal shear blade as far as possible?
Answer: If you want to avoid the wear and tear of the longitudinal shear blade, you should install it well and choose the blade with good material. In addition, the shear capacity of equipment should be high.
4. Which material is better for rubber on vertical shears?
Answer: The rubber on the vertical shear machine is better made of polyurethane because of its wear resistance, oil resistance and cold resistance, and its elastic hardness is very good.